Upload options¶

upload_port¶

This option is used by “uploader” tool when sending firmware to board via upload_port. For example,

• /dev/ttyUSB0 - Serial port (Unix-based OS)

• COM3 - Serial port (Windows OS)

• 192.168.0.13 - IP address when using OTA

• /media/disk - physical path to media disk/flash drive (mbed enabled boards)

• D: - physical path to media disk/flash drive (Windows OS).

If upload_port isn’t specified, then PlatformIO will try to detect it automatically.

To print all available serial ports use platformio device list command.

This option can be set by global environment variable PLATFORMIO_UPLOAD_PORT.

Please note that you can use Unix shell-style wildcards:

Example

[env:uno]
platform = atmelavr
framework = arduino
; any port that starts with /dev/ttyUSB
upload_port = /dev/ttyUSB*

; COM1 or COM3
upload_port = COM[13]

upload_protocol¶

A protocol that “uploader” tool uses to talk to a board. Please check Boards for supported uploading protocols by your board.

upload_speed¶

A connection speed (baud rate) which “uploader” tool uses when sending firmware to board.

upload_flags¶

Extra flags for uploader. Will be added to the end of uploader command. If you need to override uploader command or base flags please use extra_scripts.

This option can be set by global environment variable PLATFORMIO_UPLOAD_FLAGS.

Example

Please specify each flag/option in a new line starting with minimum 2 spaces.

[env:atmega328pb]
platform = atmelavr
board = atmega328pb
framework = arduino
upload_flags =
  -P$UPLOAD_PORT
  -b$UPLOAD_SPEED
  -u
  -Ulock:w:0xCF:m
  -Uhfuse:w:0xD7:m
  -Uefuse:w:0xF6:m
  -Ulfuse:w:0xE2:m

upload_resetmethod¶

Specify reset method for “uploader” tool. This option isn’t available for all development platforms. The only Espressif 8266 supports it.