Altera / Intel USB-Blaster Download Cable¶
USB Blaster Download Cable is designed for ALTERA FPGA, CPLD, Active Serial Configuration Devices and Enhanced Configuration Devices, USB 2.0 connection to the PC and JTAG, AS, PS to the target device. Official reference can be found here.
Configuration¶
You can configure debugging tool using debug_tool option in “platformio.ini” (Project Configuration File):
[env:myenv]
platform = ...
board = ...
debug_tool = altera-usb-blaster
If you would like to use this tool for firmware uploading, please change upload protocol:
[env:myenv]
platform = ...
board = ...
debug_tool = altera-usb-blaster
upload_protocol = altera-usb-blaster
More options:
Drivers¶
Please install official drivers.
Wiring Connections¶
JTAG Interface¶
USB-Blaster JTAG 10-Pin Connector |
Board JTAG Pin |
Description |
|---|---|---|
1 |
TCK |
JTAG Return Test Clock |
2 |
GND |
Digital ground |
3 |
TDO |
Test Data Out pin |
4 |
VCC |
Positive Supply Voltage — Power supply for JTAG interface drivers |
5 |
TMS |
Test Mode State pin |
9 |
TDI |
Test Data In pin |
Platforms¶
Name |
Description |
|---|---|
The GigaDevice GD32V device is a 32-bit general-purpose microcontroller based on the RISC-V core with an impressive balance of processing power, reduced power consumption and peripheral set. |
Frameworks¶
Name |
Description |
|---|---|
Arduino Wiring-based Framework allows writing cross-platform software to control devices attached to a wide range of Arduino boards to create all kinds of creative coding, interactive objects, spaces or physical experiences. |
|
GigaDevice GD32VF103 Firmware Library (SDK) |
Boards¶
Note
For more detailed board information please scroll tables below by horizontal.
Name |
Platform |
Debug |
MCU |
Frequency |
Flash |
RAM |
|---|---|---|---|---|---|---|
External |
GD32VF103VBT6 |
108MHz |
128KB |
32KB |
||
External |
GD32VF103CBT6 |
108MHz |
128KB |
32KB |
||
External |
GD32VF103CBT6 |
108MHz |
128KB |
32KB |