UM232H¶
The UM232H is a USB-to-serial/FIFO development module in the FTDI product range which utilizes the FT232H USB Hi-Speed (480Mb/s) single-port bridge chip to handle the USB signaling and protocols. Official reference can be found here
Configuration¶
You can configure debugging tool using debug_tool option in “platformio.ini” (Project Configuration File):
[env:myenv]
platform = ...
board = ...
debug_tool = um232h
If you would like to use this tool for firmware uploading, please change upload protocol:
[env:myenv]
platform = ...
board = ...
debug_tool = um232h
upload_protocol = um232h
More options:
Drivers¶
- Windows:
See https://community.platformio.org/t/esp32-pio-unified-debugger/4541/20
- Mac:
macOS contains default FTDIUSBSerialDriver driver which conflicts with debug tools which are based on this chip. FTDI Chip company recommends removing this default driver from a system. Everything should work after system rebooting. See detailed instruction in official application note (Page 16, Section 4: Uninstalling FTDI Drivers on OS X) AN134: FTDI Drivers Installation guide for MAC OS X
- Linux:
Please install “udev” rules 99-platformio-udev.rules. If you already installed them before, please check that your rules are up-to-date or repeat steps.
Wiring Connections¶
Please read 4. UM232H Pin Out and Signal Descriptions section for details.
UM232H Pin |
Board JTAG Pin |
Description |
|---|---|---|
GND |
GND |
Digital ground |
AD0 |
TCK |
JTAG Return Test Clock |
AD1 |
TDI |
Test Data In |
AD2 |
TDO |
Test Data Out |
AD3 |
TMS |
Test Mode State |
RST# |
RESET |
Connect this pin to the (active low) reset input of the target CPU (EN for ESP32) |
You will also need to connect VIO to V3V and USB to 5V0 of UM232H to power the FTDI chip and board. See UM232H Datasheet
Platforms¶
Name |
Description |
|---|---|
The GigaDevice GD32V device is a 32-bit general-purpose microcontroller based on the RISC-V core with an impressive balance of processing power, reduced power consumption and peripheral set. |
Frameworks¶
Name |
Description |
|---|---|
Arduino Wiring-based Framework allows writing cross-platform software to control devices attached to a wide range of Arduino boards to create all kinds of creative coding, interactive objects, spaces or physical experiences. |
|
GigaDevice GD32VF103 Firmware Library (SDK) |
Boards¶
Note
For more detailed board information please scroll tables below by horizontal.
Name |
Platform |
Debug |
MCU |
Frequency |
Flash |
RAM |
|---|---|---|---|---|---|---|
External |
GD32VF103VBT6 |
108MHz |
128KB |
32KB |
||
External |
GD32VF103CBT6 |
108MHz |
128KB |
32KB |
||
External |
GD32VF103CBT6 |
108MHz |
128KB |
32KB |