isotptun - manual page for isotptun 2018.02.0-1
isotptun [options] <CAN interface>
isotptun - IP over CAN ISO-TP (ISO15765-2) tunnel /
proof-of-concept.
This program creates a Linux tunnel netdevice 'ctunX' and
transfers the ethernet frames inside ISO15765-2 (unreliable) datagrams on
CAN.
- -s <can_id>
- (source can_id. Use 8 digits for extended IDs)
- -d <can_id>
- (destination can_id. Use 8 digits for extended IDs)
- -n <name>
- (name of created IP netdevice. Default: 'ctun%d')
- -x
<addr>[:<rxaddr>]
- (extended addressing / opt. separate rxaddr)
- -L
<mtu>:<tx_dl>:<tx_flags>
- (link layer options for CAN FD)
- -p [tx]:[rx]
- (set and enable tx/rx padding bytes)
- -P <mode>
- (check rx padding for (l)ength (c)ontent (a)ll)
- -t <time ns>
- (transmit time in nanosecs)
- -b <bs>
- (blocksize. 0 = off)
- -m <val>
- (STmin in ms/ns. See spec.)
- -w <num>
- (max. wait frame transmissions.)
- -D
- (daemonize to background when tun device created)
- -h
- (half duplex mode.)
- -v
- (verbose mode. Print symbols for tunneled msgs.)
CAN IDs and addresses are given and expected in hexadecimal
values. Use e.g. 'ifconfig ctun0 123.123.123.1 pointopoint 123.123.123.2 up'
to create a point-to-point IP connection on CAN.