NAME

iceprog - simple programming tool for FTDI-based Lattice iCE programmers

SYNOPSIS

iceprog [options] <filename>

DESCRIPTION

Notes for iCEstick (iCE40HX-1k devel board):

  An unmodified iCEstick can only be programmed via the serial flash.


  Direct programming of the SRAM is not supported. For direct SRAM


  programming the flash chip and one zero ohm resistor must be desoldered


  and the FT2232H SI pin must be connected to the iCE SPI_SI pin, as shown


  in this picture: http://www.clifford.at/gallery/2014-elektronik/IMG_20141115_183838

  Make sure that the jumper settings on the board match the selected


  mode (SRAM or FLASH). See the iCE40-HX8K user manual for details.

OPTIONS

-d <device-string>

use the specified USB device:

-I [ABCD]

connect to the specified interface on the FTDI chip

-r

read entire flash (32Mb / 4MB) and write to file

-R

read first 256 kB from flash and write to file

-c

do not write flash, only verify (check)

-b

bulk erase entire flash before writing

-n

do not erase flash before writing

-S

perform SRAM programming

-t

just read the flash ID sequence

-v

verbose output

AUTHOR

This manual page was written by Ruben Undheim <ruben.undheim@gmail.com> for the Debian project (and may be used by others).