MLX5EN(4) | Device Drivers Manual | MLX5EN(4) |
mlx5en
— Mellanox
ConnectX-4, ConnectX-4 LX and ConnectX-5 based 100Gb, 50Gb, 40Gb, 25Gb and
10Gb Ethernet adapter driver
To compile this driver into the kernel, place the following lines in your kernel configuration file:
options COMPAT_LINUXKPI
options RATELIMIT
device mlx5
device mlx5en
To load the driver as a module at run-time, run the following command as root:
kldload mlx5en
To load the driver as a module at boot time, place the following lines in loader.conf(5):
mlx5en_load="YES"
The mlx5en
driver provides support for PCI
Express Ethernet adapters based on ConnectX-4, ConnectX-4 LX and ConnectX-5.
The driver supports Jumbo Frames, Transmit/Receive checksum offload, TCP
segmentation offload (TSO), Large Receive Offload (LRO), HW Large Receive
Offload (HW LRO), VLAN tag insertion/extraction, VLAN checksum offload, VLAN
TSO, hardware rate limiting (TXRTLMT) and Receive Side Steering (RSS).
The network interface is named mce.
For further hardware information and questions related to hardware
requirements, see http://www.mellanox.com/.
For more information on configuring this device, see ifconfig(8).
The mlx5en
driver supports 100Gb, 50Gb,
40Gb, 25Gb and 10Gb Ethernet adapters. ConnectX-5
supports:10/20/25/40/50/56/100Gb/s speeds. ConnectX-4
supports:10/20/25/40/50/56/100Gb/s speeds. ConnectX-4 LX
supports:10/25/40/50Gb/s speeds (and reduced power consumption) :
For general information and support, go to the Mellanox support website at: http://www.mellanox.com/.
If an issue is identified with this driver with a supported adapter, email all the specific information related to the issue to <freebsd-drivers@mellanox.com>.
The mlx5en
device driver first appeared in
FreeBSD 11.0.
The mlx5en
driver was written by
Mellanox Technologies
<freebsd-drivers@mellanox.com>.
May 29, 2018 | Debian |