NG_RFC1490(4) | Device Drivers Manual | NG_RFC1490(4) |
ng_rfc1490
— RFC
1490 netgraph node type
#include
<netgraph/ng_rfc1490.h>
The rfc1490
node type performs protocol
encapsulation, de-encapsulation, and multiplexing according to RFC 1490
(which has since been updated by RFC 2427). This particular type of
encapsulation is often used on top of frame relay DLCI channels.
The downstream
hook is used to transmit
and receive encapsulated frames. On the other side of the node, the
inet
and ppp
hooks are used
to transmit and receive raw IP frames and PPP frames, respectively. PPP
frames are transmitted and received according to RFC 1973; in particular,
frames appearing on the ppp
hook begin with the PPP
protocol number. The ethernet
hook can be used to
transmit and receive Ethernet frames (without a checksum) in RFC 1490's
bridging format.
Typically the inet
hook is connected to
the inet
hook of an ng_iface(4)
node.
This node type supports the following hooks:
This node type supports the generic control messages, plus the following:
NGM_RFC1490_SET_ENCAP
(setencap
)ietf-ip
"ietf-snap
"cisco
"NGM_RFC1490_GET_ENCAP
(getencap
)This node shuts down upon receipt of a
NGM_SHUTDOWN
control message, or when all hooks have
been disconnected.
netgraph(4), ng_frame_relay(4), ng_iface(4), ngctl(8)
C. Brown and A. Malis, Multiprotocol Interconnect over Frame Relay, RFC 2427.
W. Simpson, PPP in Frame Relay, RFC 1973.
http://www.cisco.com/warp/public/121/frf8modes.pdf
The ng_rfc1490
node type was implemented
in FreeBSD 4.0.
Julian Elischer <julian@FreeBSD.org>
Not all of RFC 1490 is implemented.
January 19, 1999 | Debian |