NAME

oce — Device driver for Emulex OneConnect 10Gb network adapters

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

if_oce_load="YES"

DESCRIPTION

Emulex OneConnect adapters come in various skews and with different combinations of NIC, FCoE and iSCSI functions. The oce driver claims the NIC functions in all these adapters.

The oce driver supports VLAN Hardware offload, TCP checksum offload, TCP segmentation offload (TSO), Large receive offload (LRO), Bonding, Jumbo frames (from 1500 - 9000), Multiple TX queues, Receive-Side Scaling (RSS) and MSI-X interrupts.

HARDWARE

The oce driver supports the following network adapters:

• Emulex BladeEngine 2
• Emulex BladeEngine 3
• Emulex Lancer

UPDATING FIRMWARE

Adapter firmware updates are persistent.

Firmware can be updated by following the steps below:

1. Copy the below code to a Makefile:

   KMOD=elxflash
   FIRMWS=imagename.ufi:elxflash
   .include <bsd.kmod.mk>

2. Replace imagename in above with UFI file name
3. Copy Makefile and UFI file to a directory
4. Execute make & copy generated elxflash.ko to /lib/modules
5. sysctl dev.oce.<if_id>.fw_upgrade=elxflash
6. Reboot the machine

In case of issues with supplied UFI, flashing fails with one of the following errors.

1. "Invalid BE3 firmware image"
2. "Invalid Cookie. Firmware image corrupted ?"
3. "cmd to write to flash rom failed."

SUPPORT

For general information and support, go to the Emulex website at: http://www.Emulex.com/ or E-Mail at freebsd-drivers@emulex.com.

SEE ALSO

ifconfig(8)

AUTHORS

The oce driver was written by freebsd-drivers@emulex.com.