gpx - G-code to X3G converter
- -C
- Create temporary file with a copy of the machine configuration
- -C
- Create temporary file with a copy of the machine configuration
- -F
- write X3G on-wire framing data to output file
- -N h|t|ht
- Disable writing of the X3G header (start build notice), tail (end build
notice), or both
- -d
- simulated ditto printing
- -g
- Makerbot/ReplicatorG GCODE flavor
- -i
- enable stdin and stdout support for command line pipes
- -l
- log to file
- -p
- override build percentage
- -q
- quiet mode
- -r
- Reprap GCODE flavor
- -s
- enable USB serial I/O and send x3G output to 3D printer
- -t
- truncate filename (DOS 8.3 format)
- -v
- verose mode
- -w
- rewrite 5d extrusion values
- -b BAUDRATE
- Set BAUDRATE for serial I/O. Default is 115200.
- -c CONFIG
- CONFIG is the filename of a custom machine definition (ini
file).
- -e EEPROM
- EEPROM is the filename of an eeprom settings definition (ini
file).
- -f DIAMETER
- DIAMETER is the actual filament diameter in the printer.
- -m MACHINE
- MACHINE is the predefined machine type. Available configurations
are:
- c3
- = Cupcake Gen3 XYZ, Mk5/6 + Gen4 Extruder
- c4
- = Cupcake Gen4 XYZ, Mk5/6 + Gen4 Extruder
- cp4
- = Cupcake Pololu XYZ, Mk5/6 + Gen4 Extruder
- cpp
- = Cupcake Pololu XYZ, Mk5/6 + Pololu Extruder
- cxy
- = Core-XY with HBP - single extruder
- cxysz
- = Core-XY with HBP - single extruder, slow Z
- cr1
- = Clone R1 Single with HBP
- cr1d
- = Clone R1 Dual with HBP
- r1
- = Replicator 1 - single extruder
- r1d
- = Replicator 1 - dual extruder
- r2
- = Replicator 2 (default)
- r2h
- = Replicator 2 with HBP
- r2x
- = Replicator 2X
- t6
- = TOM Mk6 - single extruder
- t7
- = TOM Mk7 - single extruder
- t7d
- = TOM Mk7 - dual extruder
- z
- = ZYYX - single extruder
- zd
- = ZYYX - dual extruder
- -n SCALE
- SCALE is the coordinate system scale for the conversion (ABS =
1.0035)
- -x X, -y
Y, -z Y
- X = the x axis offset
Y = the y axis offset
Z = the z axis offset