vboxgetty.conf - config file for vboxgetty
The file /etc/isdn/vboxgetty.conf is used to configure
vboxgetty. Please read the man page vboxgetty(8) for a description of how
vboxgetty works.
Everything after "#" is ignored, as are empty lines. All
arguments must be separated by whitespace (spaces, tabs). Arguments may not
contain whitespace.
All settings before the first port command are global
settings, after a port command they only affect the current port.
- port
<string>
- ISDN device to configure.
- modeminit
<string>
- Command to initialize the modem. You should set the MSN/EAZ on which
vboxgetty should listen for incoming calls. Default is "ATZ".
- user
<string>
- Name of the user that vboxgetty will use. This user must exist in
/etc/passwd and you must use this parameter.
- group
<string>
- Name of the group that vboxgetty will use. This group must exist in
/etc/group and you must use this parameter.
- umask
<number>
- Vboxgetty will use this umask when creating new files. You must give the
umask as an octal number. Default is 077.
- dropdtrtime
<seconds>
- Number of milliseconds to hold the DTR-Line low to reset the modem.
Default value is 800.
- initpause
<number>
- Number of milliseconds to wait after initializing the modem. This is used
to compensate the delay of the "NO CARRIER" response. Default
value is 1500.
- badinitsexit
<number>
- Maximum failures with modeminit. If this number is reached, vboxgetty
exits. Default is 0.
- ringtimeout
<number>
- Time in seconds to wait for a RING. If no RING is received within this
time, no call is taken. Default is 5.
- echotimeout
<number>
- Time in seconds to wait for the echo from the modem. Default is 4.
- commandtimeout
<number>
- Time in seconds to wait for a response to a modem command. Default is 4.
- alivetimeout
<number>
- After this time in seconds vboxgetty will check if the modem is still
responding to modem commands. Default is 1800.
- compression
<string>
- Audio compression to use to record new messages. Possible values are
ADPCM-2, ADPCM-3, ADPCM-4 and ULAW. The ALAW compression mode is no longer
supported. Default is ULAW.
- spooldir
<string>
- Spool directory to use. This directory must exist. It's used for control
files of several programs. Default is /var/spool/vbox/<user>.
- vboxconfig
<string>
- Full path of the vbox config file. Default value is
<spooldir>/vbox.conf.
- freespace
<number>
- Number of bytes that must be available on the partition with the spool
directory, so that a call may be taken. Default is 0.
- debuglevel
<string>
- What messages are be written to
/var/log/vbox/vboxgetty-<device>.log. The string consists of letters
representing the severities of the messages to log (F=FATAL, E=ERROR,
W=WARNING, I=INFO, D=DEBUG, J=JUNK). Default is FEWI.
- /etc/isdn/vboxgetty.conf
- this configuration file
This manual page was written by Andreas Jellinghaus
<aj@dungeon.inka.de>, for Debian GNU/Linux and isdn4linux.