opensc-tool - generic smart card utility
The opensc-tool utility can be used from the command line
to perform miscellaneous smart card operations such as getting the card ATR
or sending arbitrary APDU commands to a card.
--version,
Print the OpenSC package release version.
--atr, -a
Print the Answer To Reset (ATR) of the card. Output is in
hex byte format
--card-driver driver, -c driver
Use the given card driver. The default is
auto-detected.
--list-algorithms,
Lists algorithms supported by card
--info, -i
Print information about OpenSC, such as version and
enabled components.
--list-drivers, -D
List all installed card drivers.
--list-files, -f
Recursively list all files stored on card.
--list-readers, -l
List all configured readers.
--name, -n
Print the name of the inserted card (driver).
--get-conf-entry conf, -G conf
Get configuration key, format: section:name:key
--set-conf-entry conf, -S conf
Get configuration key, format:
section:name:key:value
--reader num, -r num
Specify the reader to use. By default, the first reader
with a present card is used. If num is an ATR, the reader with a
matching card will be chosen.
--reset [type],
Resets the card in reader. The default reset type is
cold, but warm reset is also possible.
--send-apdu apdu, -s apdu
Sends an arbitrary APDU to the card in the format
AA:BB:CC:DD:EE:FF....
--serial
Print the card serial number (normally the ICCSN). Output
is in hex byte format
--verbose, -v
Causes opensc-tool to be more verbose. Specify
this flag several times to enable debug output in the opensc library.
--wait, -w
Wait for a card to be inserted.
opensc-tool was written by Juha Yrjölä
<juha.yrjola@iki.fi>.