mkdns323fw - build firmware images for the DNS-323 from a kernel
and initrd
mkdns323fw -k KERNEL -i INITRD [-d DEFAULTS] -p PRODUCT_ID
-c CUSTOM_ID -m MODEL_ID -o OUTPUTFILE
mkdns323fw creates firmware images suitable for upload to the
D-link DNS-323 and other, similar devices based on the same basic firmware
image, such as the Conceptronics CH3SNAS. These firmware images contain a
kernel and initrd, as well as various product-specific values and
checksums.
This command can be very dangerous; although it attempts to do
some very, very basic sanity checking, it is still quite easy to generate a
firmware file that, when loaded into your device, will kill it stone dead.
This program is not able to check that you're uploading valid data to your
device; if you brick it, you're on your own.
-k kernel, --kernel=kernel
- specify the file containing the kernel image to embed in the firmware
image. This must be a uBoot image file, as produced by mkimage(1)
with appropriate options to specify it as a kernel image. Attempts to
provide a non-uBoot file will fail, while specifying a non-kernel uBoot
file may well brick your device. This option is required.
-i initrd, --initrd=initrd
- the initrd file to embed in the firmware image. This must be a uBoot image
file, as produced by mkimage(1) with appropriate options to specify
it as a ramdisk. The tool will refuse to embed a non-uBoot file, however a
dodgy ramdisk will likely brick your device.
-d defaults.tar.gz,
--defaults=defaults.tar.gz
- The firmware format has the ability to embed a tarball with a default
configuration; if you want to do this, you may use this option to do so.
However, the devices that the author has dealt with do not require such a
thing, and leaving it out still produces a valid firmware (and one that is
a bit smaller, to boot).
-s signature, --defaults=signature
- For reasons that will probably remain unknown until the ends of time,
there are (at least) two different firmware signatures running around that
are otherwise identical in their internal structure, which are used for
different devices. This option exists to allow you to specify the
signature that you want to use in your firmware build. Valid values for
this option are currently FrodoII (the default if this option is
not specified), Chopper or Gandolf which is used in some
devices. See the table at the top of the script if you don't know which
value to use for your device.
--p product_id,
--product-id=product_id
--c custom_id, --custom-id=custom_id
--m model_id, --model-id=model_id
- Specify the product, custom, and model ID that this firmware image is
intended for. As several different devices share the same firmware format,
the intended device type is encoded in these fields. If you do not specify
the correct values for the device that you are targetting with your
firmware, it is quite likely that the device will refuse the upload.
- Known-good values for various devices are provided in the header of the
script; please look there for more information. You can also obtain the
values you need by downloading an existing firmware for the device you're
targetting and doing a bit of digging.
-o outputfile, --output=outputfile
- Where to write the completed firmware image. Will overwrite any existing
file of the same name.
E-mail bug reports to
theshed+dns323-firmware-tools@hezmatt.org. I don't guarantee to be
able to help, but I'll give it a shot. Patches are far more helpful.
mkdns323fw was written by Matt Palmer, based on
reverse-engineering work done by Leschinsky Oleg.
Copyright © 2008 Matt Palmer.
This is free software; see the source for copying conditions. There is NO
warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE,
to the extent permitted by law.