uhd_rx_nogui - GNU Radio receiver
uhd_rx_nogui.py [options]
Command line GNU Radio receiver that takes signal from a UHD
peripheral receiver and sends demodulated audio to the sound device.
- -h, --help
- show this help message and exit
- -a ARGS,
--args=ARGS
- UHD device address args , [default=]
- --spec=SPEC
- Subdevice of UHD device where appropriate
- -A ANTENNA,
--antenna=ANTENNA
- select Rx Antenna where appropriate [default=none]
- -f Hz,
--frequency=Hz
- set receive frequency to Hz [default=none]
- -c Hz,
--calibration=Hz
- set frequency offset to Hz [default=0.0]
- -g dB,
--gain=dB
- set RF gain [default is midpoint]
- -m TYPE,
--modulation=TYPE
- set modulation type (AM,FM) [default=none]
- -o RATE,
--output-rate=RATE
- set audio output rate to RATE [default=32000]
- -r dB,
--rf-squelch=dB
- set RF squelch to dB [default=-50.0]
- -p FREQ,
--ctcss=FREQ
- set CTCSS squelch to FREQ [default=none]
- -O AUDIO_OUTPUT,
--audio-output=AUDIO_OUTPUT
- pcm device name. E.g., hw:0,0 or surround51 or /dev/dsp