uhd_siggen_gui - GNU Radio signal generator using UHD hardware
uhd_siggen_gui: [options]
GUI to allow UHD supported hardware to be a signal generator.
- -h, --help
- show this help message and exit
- -a ARGS,
--args=ARGS
- UHD device address args , [default=]
- --spec=SPEC
- Subdevice of UHD device where appropriate
- -A ANTENNA,
--antenna=ANTENNA
- select Rx Antenna where appropriate
- -s SAMP_RATE,
--samp-rate=SAMP_RATE
- set sample rate (bandwidth) [default=1000000.0]
- -g GAIN,
--gain=GAIN
- set gain in dB (default is midpoint)
- -f FREQ,
--tx-freq=FREQ
- Set carrier frequency to FREQ [default=mid-point]
- -x WAVEFORM_FREQ,
--waveform-freq=WAVEFORM_FREQ
- Set baseband waveform frequency to FREQ [default=0]
- -y WAVEFORM2_FREQ,
--waveform2-freq=WAVEFORM2_FREQ
- Set 2nd waveform frequency to FREQ [default=none]
- --sine
- Generate a carrier modulated by a complex sine wave
- --const
- Generate a constant carrier
- --offset=OFFSET
- Set waveform phase offset to OFFSET [default=0]
- --gaussian
- Generate Gaussian random output
- --uniform
- Generate Uniform random output
- --2tone
- Generate Two Tone signal for IMD testing
- --sweep
- Generate a swept sine wave
- --amplitude=AMPL
- Set output amplitude to AMPL (0.0-1.0) [default=0.15]
- -v, --verbose
- Use verbose console output [default=False]