sane-magicolor - SANE backend for KONICA MINOLTA magicolor
scanners
The sane-magicolor backend supports KONICA MINOLTA
magicolor scanners connected via USB or LAN. Currently, only the magicolor
1690MF device is supported, no other devices with the same scanning protocol
are known.
The following scanner should work with this backend:
Device Details
-----------------------------
Vendor: KONICA MINOLTA
Model: magicolor 1690MF
This section describes the backend's configuration file entries.
The file is located at:
- /etc/sane.d/magicolor.conf
For a proper setup, at least one of the following entries are
needed:
- net autodiscovery
net [IP ADDRESS] [DEVICE-ID]
usb
usb [VENDOR-ID] [DEVICE-ID]
- /etc/sane.d/magicolor.conf
- The backend configuration file
- /usr/lib/x86_64-linux-gnu/sane/libsane-magicolor.a
- The static library implementing this backend.
- /usr/lib/x86_64-linux-gnu/sane/libsane-magicolor.so
- The shared library implementing this backend (present on systems that
support dynamic loading).
- SANE_CONFIG_DIR
- This environment variable specifies the list of directories that may
contain the configuration file. Under UNIX, the directories are separated
by a colon (`:'), under OS/2, they are separated by a semi-colon (`;'). If
this variable is not set, the configuration file is searched in two
default directories: first, the current working directory (".")
and then in /etc/sane.d. If the value of the environment variable ends
with the directory separator character, then the default directories are
searched after the explicitly specified directories. For example, setting
SANE_CONFIG_DIR to "/tmp/config:" would result in
directories "/tmp/config", ".", and
"/etc/sane.d" being searched (in this order).
- SANE_DEBUG_MAGICOLOR
- If the library was compiled with debug support enabled, this environment
variable controls the debug level for this backend. Higher debug levels
increase the verbosity of the output.
Example: export SANE_DEBUG_MAGICOLOR=127
To obtain debug messages from the backend, set this
environment variable before calling your favorite frontend (e.g.
xscanimage).
Example: SANE_DEBUG_MAGICOLOR=65 xscanimage
Large color scans may sometimes timeout due to unknown reasons
(the scanner simply stops returning data)
Cancelling large scans may lock up the scanner.
sane(7),
http://wiki.kainhofer.com/hardware/magicolor_scan
Reinhold Kainhofer <reinhold@kainhofer.com>