-i, --input=<file>
Input file name. (default: perf.data unless stdin is a
fifo)
-d, --dsos=<dso[,dso...]>
Only consider symbols in these dsos.
-s, --symbol=<symbol>
Symbol to annotate.
-f, --force
Don’t do ownership validation.
-v, --verbose
Be more verbose. (Show symbol address, etc)
-q, --quiet
Do not show any message. (Suppress -v)
-n, --show-nr-samples
Show the number of samples for each symbol
-D, --dump-raw-trace
Dump raw trace in ASCII.
-k, --vmlinux=<file>
vmlinux pathname.
--ignore-vmlinux
Ignore vmlinux files.
-m, --modules
Load module symbols. WARNING: use only with -k and LIVE
kernel.
-l, --print-line
Print matching source lines (may be slow).
-P, --full-paths
Don’t shorten the displayed pathnames.
--stdio
Use the stdio interface.
--stdio2
Use the stdio2 interface, non-interactive, uses the TUI
formatting.
--stdio-color=<mode>
always, never or auto, allowing
configuring color output via the command line, in addition to via
"color.ui" .perfconfig. Use --stdio-color always to generate
color even when redirecting to a pipe or file. Using just --stdio-color
is equivalent to using always.
--tui
Use the TUI interface. Use of --tui requires a tty, if
one is not present, as when piping to other commands, the stdio interface is
used. This interfaces starts by centering on the line with more samples,
TAB/UNTAB cycles through the lines with more samples.
--gtk
Use the GTK interface.
-C, --cpu=<cpu>
Only report samples for the list of CPUs provided.
Multiple CPUs can be provided as a comma-separated list with no space: 0,1.
Ranges of CPUs are specified with -: 0-2. Default is to report samples on all
CPUs.
--asm-raw
Show raw instruction encoding of assembly
instructions.
--show-total-period
Show a column with the sum of periods.
--source
Interleave source code with assembly code. Enabled by
default, disable with --no-source.
--symfs=<directory>
Look for files with symbols relative to this
directory.
-M, --disassembler-style=
Set disassembler style for objdump.
--objdump=<path>
Path to objdump binary.
--prefix=PREFIX, --prefix-strip=N
Remove first N entries from source file path names in
executables and add PREFIX. This allows to display source code compiled on
systems with different file system layout.
--skip-missing
Skip symbols that cannot be annotated.
--group
Show event group information together
--percent-type
Set annotation percent type from following choices:
global-period, local-period, global-hits, local-hits
The local/global keywords set if the percentage is computed
in the scope of the function (local) or the whole data (global).
The period/hits keywords set the base the percentage is computed
on - the samples period or the number of samples (hits).