netctl - Control the netctl network profile manager
netctl {COMMAND} [PROFILE]
netctl [--help | --version]
netctl may be used to introspect and control the state of
the systemd services for the network profile manager.
The following commands are understood:
list
List all available profiles. Online profiles will be
marked with a ‘*’, otherwise active profiles will be marked with
a ‘+’.
store
Saves which profiles are currently active.
restore
Loads the profiles that were active during the last
invocation of ‘store’.
stop-all
Stops all active network profiles.
start [PROFILE]
Start the network profile specified on the command
line.
stop [PROFILE]
Stop the network profile specified on the command
line.
restart [PROFILE]
Restart the network profile specified on the command
line. If it is not started yet, it will be started.
switch-to [PROFILE]
Starts the network profile specified on the command line
after stopping all profiles that refer to the same interface.
is-active [PROFILE]
Check whether the network profile specified on the
command line is active. Prints the current state.
status [PROFILE]
Show terse runtime status information about a profile,
followed by its most recent log data from the journal.
enable [PROFILE]
Enable the systemd unit for the profile specified. This
will create a unit configuration file. If the file already exists, the command
fails. No other profiles than the one specified will be enabled. Changes to
the general options in a profile specification will not propagate to the unit
configuration file automatically. After such changes, it is necessary to
‘reenable’ the profile.
disable [PROFILE]
Disable the systemd unit for the profile specified. This
will remove the file created by ‘enable’ even if it was
customized, so be careful.
reenable [PROFILE]
Reenable the systemd unit for the profile specified. This
is effectively a combination of ‘disable’ and
‘enable’.
is-enabled [PROFILE]
Check whether the systemd unit for the specified profile
is enabled. Prints the current enable status.
edit [PROFILE]
Open the file of the specified profile in an editor. This
does not reenable or restart any profiles.
wait-online [PROFILE]
Wait until the interface of the profile has a routable IP
address of some kind.
On success 0 is returned, a non-zero failure code otherwise.
$NETCTL_DEBUG
If set to "yes", debugging output is generated.
The value of this variable is independent of the value of the
variable with the same name in profiles.
$NETCTL_STATE_FILE
The location of the state file. Defaults to
/var/lib/netctl/netctl.state.