DOKK / manpages / debian 11 / python3-ethtool / pethtool3.8.en
PETHTOOL(8)   PETHTOOL(8)

pethtool - Display or change ethernet card settings

pethtool [OPTIONS] [<INTERFACE>]

This script mimic ethtool behavior, but is written purely in python and python module ethtool.

INTERFACE

Is the name of the ethernet device on which pethtool should operate.

-h, --help

Show help message and exit.

-c|--show-coalesce

Show coalesce options

-C|--coalesce

Set coalesce options 

adaptive-rx on|off
adaptive-tx on|off
rx-usecs N
rx-frames N
rx-usecs-irq N
rx-frames-irq N
tx-usecs N
tx-frames N
tx-usecs-irq N
tx-frames-irq N
stats-block-usecs N
pkt-rate-low N
rx-usecs-low N
rx-frames-low N
tx-usecs-low N
tx-frames-low N
pkt-rate-high N
rx-usecs-high N
rx-frames-high N
tx-usecs-high N
tx-frames-high N
sample-interval N

-i|--driver

Show driver information

-k|--show-offload

Get protocol offload information

-K|--offload

Set protocol offload

[ tso on|off ]

ethtool(8)

Arnaldo Carvalho de Melo <acme@redhat.com>

Man page written by Miroslav Suchý <msuchy@redhat.com>

12/07/2020