simulpic - Microchip PIC 16F84 simulator
simulpic is a program that simulates the behaviour of a
Microchip 16F84 microcontroller.
The program presents a command line interface and accepts the
following commands:
- h
- Give a summary of all the commands
- l <filename>
- Read program memory from IHX8M-format file <filename>
- dr
- View registers
- dg
- View general registers
- dee
- View EEPROM data memory
- dpm
- View program memory
- dp
- View IO pins state
- ds
- View stack
- d [<address>]
- Disassemble from <address> (or PC)
- s [<number>]
- Execute <number> steps
- g <time>
- Execute until <time>
- bp
[<address>]
- Set/clear breakpoint
- pa ppppp
- Set RA io_port state (p = 0, 1, -, u)
- pb ppppp
- Set RB io_port state (p = 0, 1, -, u)
- pm p
- Set MCLR state (p = 0, 1)
- io
[<filename>]
- Open inputs file
- ic
- Close inputs file
- ro
[<filename>]
- Open report file
- rc
- Close report file
- eo
[<filename>]
- Open graphic file
- ec
- Close graphic file
- st
- Set sampling frequency (# instr.) for graphics file
- f
- Set clock frequency
- por
- Power-on reset
- q
- Quit
This program has no options.
You can find more information about the PIC 16F84 microcontroller
on the Microchip WWW site http://www.microchip.com/
This manual page was written by Samuel Tardieu
<sam@debian.org> and revised by Deva Seetharam (deva@alum.mit.edu),
for the Debian GNU/Linux system (but may be used by others).