coregpm.doris - perform step COREGPM iteratively from prompt.
coregpm.doris v1.0, FMR software, Rens Swart (c)2001\n
- Fit model through the coregistration vectors estimated by FINE;
- (ii) Select the vector with largest w-test and ask user whether it
- should be removed. If so, remove it, and re-run Doris (goto (i)). If not,
stop.
- The advantage of this script is that normally the result file needed to be
edited after each iteration to fit the model. Note that the inputfile of
Doris should contain cards for the resultfiles, run step coregpm, screen
info, etc.
- SYNOPSIS:
- coregpm.doris [-V] Doris_inputfile
- OPTIONS:
- -V
- Verbose flag, default redirect stdout to file:
".doris.stdout.20:25"
- input
- Doris input file for step coregpm, if you use run, it is like
Inputfiles/input.resample
- EXAMPLE:
- To run Doris without messages to the screen, assuming you have a input
file named input.cpm, use the following command:
- coregpm.doris input.cpm
- BUGS:
- - Doris input keywords must be in capitals. - Assume section
Start_comp_coregpm is not in result file. - Assume plotcpm is not ran from
within Doris (CPM_PLOT OFF). - coregpm.doris output interferes with
plotcpm output on screen (if CPM_PLOT ON) (?).
- SEE ALSO:
- - http://www.geo.tudelft.nl/doris/ (online user's manual) - phasefilt.fast
- helpdoris - run
- PROGRAM: coregpm.doris -- Perform step COREGPM iteratively from
prompt.
- (i)
- Fit model through the coregistration vectors estimated by FINE;
- (ii) Select the vector with largest w-test and ask user whether it
- should be removed. If so, remove it, and re-run Doris (goto (i)). If not,
stop.
- The advantage of this script is that normally the result file needed to be
edited after each iteration to fit the model. Note that the inputfile of
Doris should contain cards for the resultfiles, run step coregpm, screen
info, etc.
- SYNOPSIS:
- coregpm.doris [-V] Doris_inputfile
- OPTIONS:
- -V
- Verbose flag, default redirect stdout to file:
".doris.stdout.20:25"
- input
- Doris input file for step coregpm, if you use run, it is like
Inputfiles/input.resample
- EXAMPLE:
- To run Doris without messages to the screen, assuming you have a input
file named input.cpm, use the following command:
- coregpm.doris input.cpm
- BUGS:
- - Doris input keywords must be in capitals. - Assume section
Start_comp_coregpm is not in result file. - Assume plotcpm is not ran from
within Doris (CPM_PLOT OFF). - coregpm.doris output interferes with
plotcpm output on screen (if CPM_PLOT ON) (?).
- SEE ALSO:
- - http://www.geo.tudelft.nl/doris/ (online user's manual) - phasefilt.fast
- helpdoris - run
The full documentation for ?[3J?[H?[2Jcoregpm.doris is
maintained as a Texinfo manual. If the info and
?[3J?[H?[2Jcoregpm.doris programs are properly installed at your
site, the command
- info ?[3J?[H?[2Jcoregpm.doris
should give you access to the complete manual.