GTKTerm - A simple GTK+ serial port terminal
gtkterm is a simple GTK+ terminal used to communicate with
the serial port.
gtkterm accepts the following options:
-h, --help Help screen.
- -c, --config
<configuration>
- Load configuration (default is "default").
- -p, --port
<device>
- Serial port device (default /dev/ttyS0).
- -s, --speed
<speed>
- Serial port speed (default 115200).
- -b, --bits
<bits>
- Number of bits (default 8).
- -t, --stopbits
<stopbits>
- Number of stopbits (default 1).
- -a, --parity <odd |
even>
- Partity (default none).
- -w, --flow <Xon |
CTS>
- Flow control (default none).
- -d, --delay
<ms>
- End of line delay in ms (default none).
- -r, --char
<char>
- Wait for a special char at end of line (default none).
- -f, --file
<filename>
- Default file to send (default none).
- -e, --echo
- Set local echo.
- -x, --rts_time_before
<ms>
- For rs485, time in ms before transmit with rts on
- -y, --rts_time_after
<ms>
- For rs485, time in ms after transmit with rts on
- -e, --echo
- Switch on local echo
- -L,
--disable-port-lock
- Do not lock serial port. Allows to send to serial port from different
terminals.
gtkterm was written by Julien Schmitt. Maintained at
https://github.com/Jeija/gtkterm by Willem van den Akker, Florian
Euchner
This manual page was written by Sebastien Bacher
<seb128@debian.org>, for the Debian GNU/Linux system (but may be used
by others).