arping - send ARP REQUEST to a neighbour host
arping [-AbDfhqUV]
[-c count]
[-w deadline]
[-i interval]
[-s source]
[-I interface] {destination}
Ping destination on device interface by ARP packets,
using source address source.
arping supports IPv4 addresses only. For IPv6, see
ndisc6(8).
-A
The same as -U, but ARP REPLY packets used instead
of ARP REQUEST.
-b
Send only MAC level broadcasts. Normally arping
starts from sending broadcast, and switch to unicast after reply
received.
-c count
Stop after sending count ARP REQUEST packets. With
deadline option, instead wait for count ARP REPLY packets, or
until the timeout expires.
-D
Duplicate address detection mode (DAD). See RFC2131,
4.4.1. Returns 0, if DAD succeeded i.e. no replies are received.
-f
Finish after the first reply confirming that target is
alive.
-I interface
Name of network device where to send ARP REQUEST
packets.
-h
Print help page and exit.
-q
Quiet output. Nothing is displayed.
-s source
IP source address to use in ARP packets. If this option
is absent, source address is:
• In DAD mode (with option -D) set to
0.0.0.0.
• In Unsolicited ARP mode (with options -U
or -A) set to destination.
• Otherwise, it is calculated from routing
tables.
-U
Unsolicited ARP mode to update neighbours' ARP caches. No
replies are expected.
-V
Print version of the program and exit.
-w deadline
Specify a timeout, in seconds, before arping exits
regardless of how many packets have been sent or received. If any replies are
received, exit with status 0, otherwise status 1. When combined with the
count option, exit with status 0 if count replies are received
before the deadline expiration, otherwise status 1.
-i interval
Specify an interval, in seconds, between packets.
arping was written by Alexey Kuznetsov
<kuznet@ms2.inr.ac.ru>.
arping requires CAP_NET_RAW capability to be executed. It
is not recommended to be used as set-uid root, because it allows user to
modify ARP caches of neighbour hosts.
arping is part of iputils package.