DOKK / manpages / debian 12 / mia-tools / mia-3disosurface-from-stack.1.en
mia-3disosurface-from-stack(1) General Commands Manual mia-3disosurface-from-stack(1)

mia-3disosurface-from-stack - Extract an ist-surface froma a 3D image.

mia-3disosurface-from-stack -i <in-image> -o <out-mesh> [options]

mia-3disosurface-from-stack This program is used to extract an iso-surface from the input gray scale image given as slices.

input image filename pattern

output mesh

verbosity of output, print messages of given level and higher priorities. Supported priorities starting at lowest level are:

trace ‐ Function call trace
debug ‐ Debug output
info ‐ Low level messages
message ‐ Normal messages
warning ‐ Warnings
fail ‐ Report test failures
error ‐ Report errors
fatal ‐ Report only fatal errors
print copyright information

print this help

-? --usage
print a short help

print the version number and exit

iso-value of iso surface to be extracted

maximum number of Faces,

maximum number of Edges

maximum cost for edge collaps

ratio of faces(edges) to target number, at which the optimization changes from edge-length to volume-optimized

reverse the winding of the triangles in order to make normals point away from the high intensity area

Maxiumum number of threads to use for processing,This number should be lower or equal to the number of logical processor cores in the machine. (-1: automatic estimation).

Extract the surface from an image set with numbers imageXXXX.png that corresponds to the value 30 and stop optimizing when the mesh consists of less than 100000 triangles.

mia-3disosurface-from-stack -i image0000.png -o mesh.vmesh -s 30 -f 100000

Gert Wollny

This software is Copyright (c) 1999‐2015 Leipzig, Germany and Madrid, Spain. It comes with ABSOLUTELY NO WARRANTY and you may redistribute it under the terms of the GNU GENERAL PUBLIC LICENSE Version 3 (or later). For more information run the program with the option '--copyright'.

v2.4.7 USER COMMANDS