| MCONCATFIT(1) | Montage | MCONCATFIT(1) |
mConcatFit - Merge multiple plane fit parameter files into one file
mConcatFit [-d] [-s statusfile] statfiles.tbl fits.tbl statdir
Merge multiple plane fit parameter files (from mFitplane) into one file. This module is only needed in a Grid environment where the mFitplane jobs may run in parallel on computers that do not share a file system. In this case, the fit parameters have to be merged into one file before mBgModel can be called.
This module have been used extensively but have not been subject to the same rigorous testing to which the core modules have been subjected. We advise users to contact Montage (montage@ipac.caltech.edu) before employing them to verify limitations in their use and changes in the interfaces.
2001-2014 California Institute of Technology, Pasadena, California
If your research uses Montage, please include the following acknowledgement: "This research made use of Montage. It is funded by the National Science Foundation under Grant Number ACI-1440620, and was previously funded by the National Aeronautics and Space Administration's Earth Science Technology Office, Computation Technologies Project, under Cooperative Agreement Number NCC5-626 between NASA and the California Institute of Technology."
The Montage distribution includes an adaptation of the MOPEX algorithm developed at the Spitzer Science Center.
| June 2010 | Montage 3.3 |