--version
Print the OpenSC package release version.
--atr, -a
Print the Answer To Reset (ATR) of the card. Output is in
hex byte format
--card-driver driver, -c driver
Use the given card driver. The default is to auto-detect
the correct card driver. The literal value ? lists all available card
drivers.
--list-algorithms,
Lists algorithms supported by card
--info, -i
Print information about OpenSC, such as version and
enabled components.
--list-drivers, -D
List all installed card drivers.
--list-files, -f
Recursively list all files stored on card.
--list-readers, -l
List all configured readers.
--name, -n
Print the name of the inserted card (driver).
--get-conf-entry conf, -G conf
Get configuration key, format: section:name:key
--set-conf-entry conf, -S conf
Set configuration key, format:
section:name:key:value
--reader arg, -r arg
Number of the reader to use. By default, the first reader
with a present card is used. If arg is an ATR, the reader with a
matching card will be chosen.
--reset [type],
Resets the card in reader. The default reset type is
cold, but warm reset is also possible.
--send-apdu apdu, -s apdu
Sends an arbitrary APDU to the card in the format
AA:BB:CC:DD:EE:FF.... Use this option multiple times to send more than one
APDU.
The built-in card drivers may send additional APDUs for detection
and initialization. To avoid this behavior, you may additionally specify
--card-driver default.
--serial
Print the card serial number (normally the ICCSN). Output
is in hex byte format
--verbose, -v
Causes opensc-tool to be more verbose. Specify
this flag several times to enable debug output in the opensc library.
--wait, -w
Wait for a card to be inserted.