snek-itsybitsy-install - Install Snek to Adafruit ItsyBitsy
board
snek-itsybitsy-install [OPTION]... [COMMAND]
snek-itsybitsy-install installs the Snek programming
language on an Adafruit ItsyBitsy board with an ATmega32u4.
- -isp <ISP model>
- Specifies the programmer to use, common options are 'usbtiny' and
'avrisp2'. The default is 'usbtiny'.
- -hex <snek.hex>
- Specifies the hex file to load to the board. The default is the currently
installed version of Snek.
- -3v
- Use the 3v binary instead of the default 5v binary.
- fuseload
- Sets the target fuse bits for Snek usage and then loads Snek to the
device. This is the default command
- load
- Loads Snek to the device without first setting the fuse bits. Snek will
not work correctly if the fuse bits are not set correctly, so only do this
if the target has already had the fuse bits set correctly.
- fuse
- Sets the target fuse bits suitable for Snek usage. You must do this before
Snek will work on the target device, although you may do it before or
after loading the Snek system. You only need to do this once per
board.