snek-lilypad-big-big-install - Install larger version of Snek to
Arduino ATmega328 board
snek-lilypad-big-install [OPTION]... [COMMAND]
snek-lilypad-big-install installs the larger version Snek
programming language on an Arduino board with an ATmega328, overwriting the
boot loader. This version of snek provides support for a few extra
functions, 'input', 'float' and 'int'. As a consequence, it does not leave
room for the Optiboot loader and must be flashed using a separate programmer
dongle.
- -isp <ISP model>
- Specifies the programmer to use, common options are 'usbtiny' and
'avrisp2'. The default is 'usbtiny'.
- -hex <snek.hex>
- Specifies the hex file to load to the board. The default is the currently
installed version of Snek.
- -mcu <MCU name>
- Specifies which micro controller to expect to find on the board. Some
boards have m328 while others have m328p. The default is m328p, but if you
get an error message indicating a mismatch, you can try the other.
- fuseload
- Sets the target fuse bits for Snek usage and then loads Snek to the
device. This is the default command
- load
- Loads Snek to the device without first setting the fuse bits. Snek will
not work correctly if the fuse bits are not set correctly, so only do this
if the target has already had the fuse bits set correctly.
- fuse
- Sets the target fuse bits suitable for Snek usage. You must do this before
Snek will work on the target device, although you may do it before or
after loading the Snek system. You only need to do this once per
board.