uisp - Micro In-System Programmer for Atmel's AVR MCUs
uisp [OPTION].. -dprog=TYPE
-dpart=AT90XXX --FUNCTION.. [if=SOURCE]
[of=DEST]
-dprog=<method>
- avr910
- Standard Atmel Serial Programmer/Atmel Low Cost Programmer
- pavr
- http://www.avr1.org/pavr/pavr.html
- stk500
- Atmel STK500
- dapa
- Direct AVR Parallel Access
- stk200
- Parallel Starter Kit STK200, STK300
- abb
- Altera ByteBlasterMV Parallel Port Download Cable
- atdh
- Atmel-ISP Download Cable (P/N ATDH1150VPC)
- avrisp
- Atmel AVR ISP (?)
- bsd
- http://www.bsdhome.com/avrdude/ (parallel)
- fbprg
- http://ln.com.ua/~real/avreal/adapters.html (parallel)
- dt006
- http://www.dontronics.com/dt006.html (parallel)
- maxi
- Investment Technologies Maxi (parallel)
- dm04
- Datamekatronik 2004 (parallel)
- dasa
- serial (RESET=RTS SCK=DTR MOSI=TXD MISO=CTS)
- dasa2
- serial (RESET=!TXD SCK=RTS MOSI=DTR MISO=CTS)
- dasa3
- serial (RESET=!DTR SCK=RTS MOSI=TXD MISO=CTS)
- -dpart=part
- Set target abbreviated name or number. For some programmers, if
-dpart is not given programmer's supported devices are listed. Set
-dpart=auto for auto-select. Auto-select does not work with
all programmers, so it is recommended to always specify a target device
explicitly.
- -dhiv
- Use Hi-V programming instead of SPI (default is SPI).
- --rd_aref
- Read the ARef Voltage. Note that due to a bug in the stk500 firmware, the
read value is sometimes off by 0.1 from the actual value measured with a
volt meter.
- --wr_aref=value
- Set the ARef Voltage. Valid values are 0.0 to 6.0 volts in 0.1 volt
increments. Value can not be larger than the VTarget value.
- --rd_vtg
- Read the Vtarget Voltage. Note that due to a bug in the stk500 firmware,
the read value is sometimes off by 0.1 from the actual value measured with
a volt meter.
- --wr_vtg=value
- Set the VTarget Voltage. Valid values are 0.0 to 6.0 volts in 0.1 volt
increments. Value can not be smaller than the ARef value.
- --rd_osc
- Read the oscillator frequency in Hertz.
- --wr_osc=value
- Set the oscillator frequency in Hertz, from 14.06 to 3686400.
- if=filename
- Input file for the --upload and --verify functions in
Motorola S-records (S1 or S2) or 16 bit Intel format
- of=filename
- Output file for the --download function in Motorola S-records
format, default is standard output
Report bugs to <uisp-dev@nongnu.org>
http://savannah.nongnu.org/download/uisp/
(c) 1997-1999 Uros Platise, 2000-2004 Marek Michalkiewicz
uisp is free software, covered by the GNU General Public License.
You are welcome to change it and/or distribute copies of it under the
conditions of the GNU General Public License.